This project began in California, was resumed while living in Thailand. I designed the Ultimate BiPlane from 3 view drawings and hand cut the 1st few models. This was the first time I had access to laser cutting technology, so the model was refined over several versions. When I moved to the Philippines, the foam was no longer available, so I redisigned again for 6mm foam. This foam has a paper backing on both sides so it is possible to build without a carbon spar.

 

Normally I fly this little beast WOT with violent manuevers, so I use a 3mm carbon tube on the bottom side of the lower wing.

 

I also purchased a few kits, Edge-540 and CAP-232.